Wheel cleaning and blowing method

A wheel cleaning and blowing method, wherein cleaning and blowing are decomposed into four steps:

• step 1, a flange plate on a sliding table I ascends from a low position to a high position to jack a wheel to leave a roller bed, and a flange plate on a sliding table II descends from a preset high position to the low position;
• step 2, a upper servo motor is started to drive the sliding table I and the sliding table II to move synchronously to the center, i.e., the wheel moves forward from left to right, a servo motor I is started to drive the wheel to rotate, the wheel advances while rotating, the wheel entering a cleaning system is cleaned in all directions, the upper servo motor stops working after the wheel is cleaned, and the device enters a state of going to switch a left station and a right station;
• step 3, a lower servo motor is started to drive a rotating disk to rotate 180 degrees, the left station and the right station are exchanged, at the moment, the wheel enters a blowing system from the cleaning system, and the upper servo motor is restarted to drive the sliding table I and the sliding table II to move synchronously to two ends, i.e., the wheel continues advancing while rotating and is blown;
• and step 4, after the wheel is blown, the upper servo motor stops working, the idle sliding table II moves to the initial position of the left station, the sliding table I moves to the initial position of the right station, a manipulator takes the blown wheel away and puts it to a transfer roller bed, at the moment, the flange plate at the left station is at the low position, the flange plate at the right station is at the high position, the device is restored to the state of going to clean a wheel, next wheel is prepared for cleaning, and so on.